10 / 12
PAGE 10 OF 11
JULY 2012
FLOOR SCRUBBING
Place Danger Signs if applicable.
When using Automatic-Scrubbing Machines, these are to be used in accordance with the manufacturers instructions.
When using Tank Model Scrubbing Machines, detergent is to be made up in accordance with manufacturers instructions.
Detergent is to be allowed on the floor only in sufficient quantities to generate an even foam. Scrub in the pattern indicated below:
When using normal scrubbing machine, without tank:-
Mix detergent in wringer bucket,
Apply liberally by mop to areas as above 10-15 sqm,
Scrub by machine in pattern indicated above.
Hand clean edges as required.
Rinse floor from a second wringer bucket, using a clean mop and clean water, do not use too much water.
Pick up solution by wet vacuuming or mop. When using mop change water frequently.
Mop as dry as possible.
HARD FLOORS
FLOOR SCRUBBING (Continued)
When hand scrubbing is to be carried out detergent should be liberally applied over an area of about 4-5 metres. Deek scrubber to be used to
thoroughly scrub the wet area. Soiled detergent to be picked up with mop. Rinsing to be carried out with mop and clean water. Do not use too
much water.
OH&S
Equipment to be checked before and after use and any damage or unsafe condition to be reported to
Supervisor.
Mops should NOT be left on floor when not in use, they must be placed in an upright position with mop head
uppermost or stored in Cleaners Room.
Extension leads must NOT be used in any circumstances.
Danger signs to be used where applicable.
Power leads to be checked for fraying or exposed wires, any defect to be reported to Supervisor.
Power leads to be kept behind machine at all times to prevent machine from cutting or damaging lead.
Solution must be kept away from power points and electrical switches.
MISCELLANEOUS
WALL WASHING
Place protective covers alongside wall.
Remove or cover furniture.
Wash wall upwards, one section at a time.
Wipe around electrical fittings.
Wipe over ledges, window sills and fittings.
Do NOT splash detergent on curtains, furnishings or floors. Mop up any spillage’s.
Equipment to be checked and after use any damage or unsafe condition to be reported to Supervisor.
Exercise care when wiping around electrical fittings and ensure switch is off.
OH&S
Use only a safe and secured ladder in a proper manner.
Be careful when reaching or stretching that you do not strain/sprain yourself.
REMOVING GRAFFITI
Read carefully safety instructions prior to use.
Pour graffiti remover into spray bottle. Apply spray onto appropriate spot, pause, allow for chemical to work in, then wipe with a cloth.
Repeat procedure if required.
Rinse out cloth in clean water.
Cloth to be hung out to dry.
OH&S
Follow MSDS instructions for use and dilutions of solvents.
MISCELLANEOUS
CURTAIN CLEANING
Check condition of curtains before vacuuming.
Vacuum or Dust Mop top of pelmet. When using mops ensure the mop is clean and dry.
Vacuum or Dust Mop all the curtain from top to bottom. When vacuuming take special care with fine curtains to ensure they are not sucked into
vacuum cleaner and damaged.
Refer require dry cleaning or laundering.
Check mop handle is smooth.
Mop to be left in an upright position when not in use.
OH&S
Equipment to be checked before and after use and any damage or unsafe condition reported to Supervisor.
MISCELLANEOUS